Pinhole camera
How i made my pinhole camera
I made my pinhole camera by getting a hot chocolate tub and cleaning the inside with a wipe. I then spray painted the inside and the lid black so no light could get in. After the spray paint had dryed after about 15 minuets I put black tape all over the lid to make sure no light could get through because the lid was more translucent then the tub. After I made sure there was no light getting through I cut a small square out of the tub and cut a rectangle out of a coke can to make sure the coke can covered the whole square . I used a coke can because the aluminium attracts and reflects and light this means it will keep the light out of the tub.I then got a pin and made a small whole in the centre of the aluminium. When I had made my small whole I put black tape on each side of the coke can and stuck it in my tub where the cut out square was. The last thing I did was make a shutter I made my shutter by getting a piece of black tape and I folded it over so there was a small sticky bit on the side to stick it next to the aluminium so it would cover the pin hole when I was not using my camera, to make sure that the pinhole is completely covered and no light is getting through I took another bit of tape that was quite small and stuck it over the shutter and on the tub so no light could get into my camera.